LibrePilot Forum
Development => Firmware General => Topic started by: Astro02 on January 20, 2016, 09:23:04 pm
-
can anyone explain how install libre pilot on cc3d, thanks.
-
Go to Firmware tab and take a look at Wiki page.
https://librepilot.atlassian.net/wiki/display/LPDOC/Firmware+Tab
This assumes you downloaded and installed last release
-
I dowloaded a tgz file that contain all firmware, for cc3d i need to use coptercontrol file?
-
You don't need the tgz archive for normal operation.
Just follow instructions
-
GCS software and Flight Controller firmware versions need to match, so you really should always download a whole install and use the GCS and firmware that come together in the installation.
-
Hi Astro2,
It's very easy, actually.
If you already used OP before, write down your settings or do screen shots of the settings pages.
Download the software from here: https://librepilot.atlassian.net/wiki/display/LPDOC/Downloads
Install the GCS, start the GCS. When you connect your controller, it may most likely give a warning that the firmware does not match. So go to the Firmware and press update&erase. This way your controller gets updated.
After that go through the setup wizards to get your multicopter up in the air. If you have already done some fine tuning, apply the setting using your screenshots.