LibrePilot Forum
Users => Applications - FPV => Topic started by: davmendes on January 19, 2016, 03:30:02 pm
-
Hey guys
I have been trying to flash minimosd with Gcs on my revo board, but because i use Flexi Io as pwm input from my radio receiver, i cant follow the wiki tutorial. I was thinking using the flexi or main port as telemetry and then wire the dtr cable from flexi Io port to the minim osd to flash, will this work ?
-
I don't think so.
That is kind of like asking for RxData from FlexiPort and TxData from MainPort.
-
Ok, so the only way to flash it with gcs is with the flexi Io port, right?
-
The combridge stuff / Dtr pin is only needed for programming.
Flash firmware following wiki and next in normal use, no need DTR pin so you can connect OSD to Main or flexiPort as telemetry.
-
Ok, i will try that , thanks a lot for the support :D