LibrePilot Forum

General Category => General Discussion => Topic started by: hamilc on May 07, 2019, 07:54:38 pm

Title: Color code for NAZA-M gps module
Post by: hamilc on May 07, 2019, 07:54:38 pm
Anybody know the color code for the NAZA-M gps module?

The NAZA has 4 wires colored yellow, red, brown,and orange.

What is 5 volt, gnd, tx, and rcv lines.

Tough to find any documentation on the Internet.
Title: Re: Color code for NAZA-M gps module
Post by: Tongala on May 07, 2019, 11:13:25 pm
Have a look in Wiki under GPS setup. https://librepilot.atlassian.net/wiki/spaces/LPDOC/pages/12058679/GPS+setup
Otherwise search Forum with NAZA GPS wiring.
good luck
Title: Re: Color code for NAZA-M gps module
Post by: Bobrcnut on May 07, 2019, 11:30:20 pm
This may save you some time:
+V = Red
-V (ground) = Brown
Tx = Yellow
Rx = Orange

However:  be careful if/when removing or replacing the DJI connector because it contains an insulating sealant that discolors the insulation on the individual wires.  I've modified some NAZA GPS units wherein the wire insulation has discolored, the yellow has turned green and the orange has turned yellow.  Peel back the outer (grey) insulation far enough to see the original colors.