LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: streggy on April 14, 2019, 04:48:12 pm
-
Hi,
I have an issue, that might be quite frequent, but I haven't found any helpful answer yet.
Currently my Copter had a setting to Arm the Copter with "Yaw Left" this worked quite well.
Now I tried to configure a Switch on my RC to Accessory0 and use it for arming.
Channel 6 corresponds to my switch. I configured it, but it does not work.
The Quad it on reacting at all to the switch.
A added a PDF with several screenshots of my quad configuration, that proves that the Switch is correctly recognized in the Software.
I also attached the full Configuration file of the Quad, in case you want to check Firmware or Software Versions.
Has anybody a good idea, what setting I missed and why it is not working?
I already checked this thread, but my Neutral is in the middle. (https://forum.librepilot.org/index.php?topic=1629.msg11877#msg11877 )
-
Hi,
While arming, be sure the Throttle stick is to min position. This means bellow the Throttle neutral value.
-
Thanks :)
It worked. I increased the Trotle Neutral value by 5 points.
Looks like "Yaw left" also made me reduced the throttle as I had to touch the stick.
It is always the little things... ::)