LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: Wid on October 05, 2018, 06:58:35 am
-
I have a switch I have set up and all is fine in inputs (accessory 1, S-Bus, channel 6). Graph moves as expected with switch position. But I don't know how to get it to show up on the outputs page. Where do I activate it to the output? I want # 6 output PWM. Is there somewhere to activate bank 4, which is associated with output 6? I have bank 4 set to 50Hz PWM in the top row. Only the first 4 channels (motors) appear active.
-
Take a look in Vehicle Tab and setup the Accessory <> Output mapping like here (https://librepilot.atlassian.net/wiki/spaces/LPDOC/pages/6324237/Add+a+buzzer+to+Multirotor+frame#AddabuzzertoMultirotorframe-Selectoutput)
-
Of course! Thanks.