LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: fboriero on October 02, 2018, 10:42:54 pm
-
Hi everybody!
Since yesterday I have with this strange behavior when I connect the CC3D board using a Bluetooth telemetry (HC-06)...
I can receive the data that show the attitude of the quadrotor but I am not able to send any command to the board (see the pic attached).
If I connect the USB I have no problems...
Does someone have suggestions?
Cheers
Fabrizio
-
Solved! There was a little wire in the Bluetooth module that was touching the Tx pin...