LibrePilot Forum
General Category => General Discussion => Topic started by: 1morehobby on December 16, 2015, 02:09:09 am
-
I have a new Revo board coming to replace the cc3d on my ZMR250. I was wondering which autopilot would be best. I normally fly some Fpv and acro using Ratitude mode. I don't race. I ordered the revo because of the altitude hold capabilities, I have a hard time holding altitude with the CC3D.
Hope to get some feedback from you all.
Thanks Carlos
-
I would say go with LibrePilot. Its most of the team behind OP but now with the goal to be more Open. Not sure if Taulabs support the revo but that can be an option to.
-
You should be carefull with taulabs. Once you loaded taulabs firmaware its extremely hard to shift back to any other firmware.
-
Thanks guys, I think I will Try Libre.
-
+1 Libre Pilot is the future. It's supported and developed by great guyz!
You can't go wrong with LP :)