LibrePilot Forum
General Category => General Discussion => Topic started by: MikeNH on January 05, 2018, 04:28:33 am
-
It's a blizzard here in New England so I thought it a good time to revisit setting up MinimOSD for some tuning. Rather than choosing MSP on the Revolution board's Main port, I selected ComBridge on USB VCP function and selected ComBridge on Receiver Port (FlexiIO). The result after rebooting the quad was that there no longer was any data being read.
1 - How can I get back to setting the USB VCP function port and the Receiver Port back to disabled?
2 - Am I able to do this without loosing the quad's configuration. I think (hope) that I backed up the UAV settings.
The only evidence that a connection exists is:
(http://) (Attachment)
Any help would be appreciated.
-
disconnect USB disconnect battery
firmware page press Rescue
plug in board to USB
press Safe Boot
it will boot in default settings, just go and Save a workable setup on the Hardware tab
-
On the Firmware tab all of the buttons were disabled because the "USB" button didn't have a drop-down list to choose a port. After some fiddling, I found that if I disconnected the usb cable and reconnected it, for a few seconds I could choose the COM port. Once I did that, the buttons became enabled allowing me to choose the "Safe Boot" button. Once the quad rebooted into safe mode, I was able to disable the incorrect setting on the "Hardware" tab.
Thank you for being my safety net in case I really screwed things up.
-
WOW... Thank you TheOtherCliff. You are fast. Once I posted my "solved" post, I saw you had already answered. Thank you once again.