LibrePilot Forum

General Category => General Discussion => Topic started by: Frank777 on October 10, 2017, 01:24:22 pm

Title: Using my remote and receiver from Visou Quad on my Micro CC33 - 4in1 ESC
Post by: Frank777 on October 10, 2017, 01:24:22 pm

Hi Guys,

Please assist,

I have completed my conversion on the VISOU X809,

I was wondering if its possible to use the VISOU's electronics and connect it to the CC3D.
By using the motor (+) outlets on the board and connect to the pins on the CC3D as single wires,

i have tested the board with 5v and it works perfectly... no smoke... HAHAHA!

Anyway, any advise would be great... Thanks!