LibrePilot Forum
General Category => General Discussion => Topic started by: John on September 28, 2017, 03:28:16 pm
-
Hi guys I am a new builder and so far I am enjoying it. I am stuck however I have a very basic 250 build with a cc3d and a fs r6b rx. My problem is that my rx flashes once when I plug in the bat then nothing. My cc3d has one solid blue led and one steady flashing orange light. I have not flashed the board yet. This is my third rx I thought I had been unlucky and had two bad ones. I am really hoping I haven't been unlucky enough to get 3😀. Anyone with any suggestions the help would be really appreciated. I have the power to ch1 at the moment with signal leads plugged into the other five channels. I haven't used the bind plug or tried the power to other channels as I didn't want to risk maybe wiring it wrong and damaging it which I think I may have with the first two. I can't work on it til Sunday so if you do reply and I don't get back to you straight away i am not being rude just lazy😁.
-
I thought I would just try with the bind plug and it's flashing so ignore above I am so pleased but it does mean I broke 2😀. If I get more problems I will ask for help wish me luck.
-
Wishing you good luck ,
-
Best wishes my friend. And I'm glad you're enjoying building!