LibrePilot Forum
Users => Vehicles - Fixed Wing => Topic started by: f5soh on July 14, 2015, 10:12:39 am
-
Mako FPV setup
-
https://www.youtube.com/watch?v=sD4SaP_w6Ow
-
Revo nano ?
-
Yes, RevoNano.
Current sensor, GPS, Airspeed (analog) and PPM input : All connectors used :)
-
Revo pids can be used on revo "normal" ? I'm trying to have smooth fly on Caipirinha without success, i have oscillations on yaw, don't know if it is due to the wing or to the pids
-
Not easy share PID between two wings because servo horns mount are never the same.
In fact you can use the same PID from Revo or RevoNano, on same aircraft.
Maybe you need "differential" but this differential is not firmware implemented, the only way is the old mechanical way.
Test if using Manual flight mode and quick roll left/right if you see Yaw snaking.
-
Sweet setup there f5soh :)
Decided to install my Nano and Platinum GPS in my WingWing Z-84 that I've been testing out. Trying to fit everything inside a WingWing is not that easy, not that much room to play with. No actual flight test made yet with my Nano but have the PPM working with the OPlinkMini. Have not got telemetry working with GCS and PPM at same time, been at it for too many hours so only going in circles and given up for the time.
Now finishing the placement and fixing cables and hope for better weather and testflight to be made and go back for telemetry later on.
-
Congrats for the very clean setup.
Are you able to use GPS features like RTH?
-
Sure, look video above at 1:10
or this one with autonomous flight:
https://www.youtube.com/watch?v=0B9gFimoDiw
-
Here is my flyingwing falcon evo fitted with original revo running librepilot using 8vgps, micro minimosd, x8r using sbus, immersionrc 5.8.
GPS and rate modes work a treat, fly's like it's on rails in rate
Thank you librepilot/op devs
Sent from my Nexus 5 using Tapatalk