LibrePilot Forum
General Category => General Discussion => Topic started by: hunterhand on July 23, 2017, 03:36:32 pm
-
I am relatively new to this hobby and I am experiencing problems with my rise rxs 225 setup. In the transmitter wizard libre pilot does not pick up any signal from my transmitter which is a spektrum DXE and the receiver is a spektrum AR6600T, but the receiver and transmitter are bound already?? any help is appreciated!
-
Hi,
Double check you configured and wired (whatever the wire order) as PWM input
(https://forum.librepilot.org/index.php?action=dlattach;topic=3665.0;attach=6391)
Reboot after any hardware tab changes, this mean remove battery, USB cable and connect again.
Check the receiver activity before starting the transmitter wizard, should show the input active while moving one stick.
https://librepilot.atlassian.net/wiki/display/LPDOC/Input+Configuration
In some conditions the wizard do not show sticks movements, simply define a flightmode switch in your radio.
https://forum.librepilot.org/index.php?topic=3156.msg21834#msg21834
-
One last thing is that the RC receiver does not get power from just USB. You must have flight battery plugged in.