LibrePilot Forum
Users => Vehicles - Helicopters => Topic started by: rc54321 on June 07, 2017, 05:52:32 pm
-
Thank for dropping by RC Groups and checking my CopterX cc3d thread.
Ric...
-
Hi Dave,
Do you know if there are any compatibility between LibrePilot and any of the F3 or F4 flight controller boards? Have anyone you know used one on a heli? Just starting to explore more options at a low cost that can get a heli up and flying. The F1 cc3d has been great and I am starting to migrate from cc3d to F3 or F4 board on my multirotor, that is why I asked.
Ric...
-
LP 1609 currently supports Nano, Revo and Sparky2 (all F4 boards).
'next' has preliminary support for several F3 boards.
-
That is good news. I haven't done much research yet or used lp16.09 much. Not sure what extras I am hoping for in the heli. But would love to try one in a heli for sure. Thanks TheOtherCliff.
-
It's my understanding that heli is a manual setup process with several users exchanging ideas, work flows, and uav (setup) files here in this part of the forum.