LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: Jonh on February 15, 2017, 04:31:18 pm
-
Has anyone used one of these Hobbyking R617XL cppm Receivers ???
I have just purchased one of these RX and it is supplied with a 8 Pin JST SH cable connector (Pins 1,2 and 3 are cabled up)
This cable will fit the CC3D Board 8 Pin JST receiver port !!!
Am I correct in saying that I will have to remove the Pin 3 connection on this cable and move it the Pin 8 position so that I can use PPM_PIN8+Oneshot ????
(How easy is it to relocate a Pin from one of these really small connectors ??)
-
You can move the signal wire to the pin8.
Move carefully the small plastic piece using a scalpel, remove wire and insert the wire to the new place.