LibrePilot Forum

General Category => General Discussion => Topic started by: tristi45 on January 30, 2017, 06:27:44 pm

Title: jeti setup wizard
Post by: tristi45 on January 30, 2017, 06:27:44 pm

HELP
the transmitter setup wizard is not registering my jeti ds16 i have set it to ex bus mode but dont really know how to conect it to the cc3d flight controller.
I know that the flight controller works because i had a spektrum controller setup with it. does somebody know how to use a jeti transmitter with the cc3d board?

Title: Re: jeti setup wizard
Post by: f5soh on January 30, 2017, 06:49:03 pm

At some point while browsing through the setup wizard you can find the connection diagram.
You should connect the receiver to the flexiPort, according to the diagram with Gnd, +5V and input signal (pin4)
(https://forum.librepilot.org/index.php?action=dlattach;topic=3010.0;attach=5222)

Title: Re: jeti setup wizard
Post by: TheOtherCliff on January 30, 2017, 10:27:39 pm

Do you have a flight battery plugged in?  The RC receiver is not powered if only USB is plugged in.