LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: Dgremlin on November 17, 2016, 04:37:07 pm

Title: Wizard Sets Up Motors Different
Post by: Dgremlin on November 17, 2016, 04:37:07 pm
I use One Shot 125 escs but when I use the Wizard to setup the quad, it sets motor 1 & 2 at One Shot 125 but it sets motors 3 & 4 on PWM. The manual says that when setting up manually, all motors should be set the same. I've switched them and don't see any difference in flight. Any thoughts on this?
Title: Re: Wizard Sets Up Motors Different
Post by: f5soh on November 17, 2016, 06:32:03 pm
Bank settings are applied to one channel or a set of channels, depends on board you use.

You should look at bank color / and colors applied to outputs

https://librepilot.atlassian.net/wiki/display/LPDOC/Output+Configuration#OutputConfiguration-BanksandOutputs