LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: MrKitty on August 11, 2016, 12:42:29 am

Title: Arm Disarm Switch HELP!!!!!!!!!!!!!!!!!!!!!
Post by: MrKitty on August 11, 2016, 12:42:29 am

this should be stupid simple but its not and im about to throw the cc3d and my laptop across the room i want the arm disarm on a switch so when i bend down to pick up my bird if i bump the stick the motors will stay off right now it will just cut my hands all up and brake all the props i dont like stick combos because you can disarm well flying 3d/acro CAN THE CC3D/LibrePilot  ACCOMPLISH THIS SIMPLE TASK

Title: Re: Arm Disarm Switch HELP!!!!!!!!!!!!!!!!!!!!!
Post by: f5soh on August 11, 2016, 01:17:27 am

Whats the issue ?

Go the the Input tab > Arming Settings and choose the Accessory you want as Arming switch.
This mean you previously assigned a switch with a channel output in your radio and moved the switch during transmitter wizard so the Accessory is already found.
After the wizard be sure the neutral on accessory is set at middle range.

Title: Re: Arm Disarm Switch HELP!!!!!!!!!!!!!!!!!!!!!
Post by: NicholasDavid on August 12, 2016, 03:44:55 am

A neat trick if you have a decent radio is setup the arm switch to only be active for a short period of time after a momentary switch is hit. But that's all setup through the transmitter. 

I switch arm, accessory 0, 2 position switch.  You may have to adjust the neutral value to make it arm/disarm reliably.