LibrePilot Forum

Users => Vehicles - Ground => Topic started by: miker on June 19, 2016, 11:33:15 am

Title: RC car not responding after re-start
Post by: miker on June 19, 2016, 11:33:15 am
I set up an old Duratrax Evader with a CC3D Nano. It's only a two channel radio, so I locked it into "Stabilize 1", and "always armed".

Or at least I think I did.

I set the stabilisation mode "1" to "Stabilize 1".

It ran great the first time - I configured it, then took it straight outside without restarting it and fanged it around.

After I turned it off and back on again, however, it's completely unresponsive.  I plugged it back in to the computer, and it showed as "armed" in the flight info, and the RC channgels were responding - moving the wheel and throttle got the intended result.

Is there something I'm missing?

Also, is there a way to manually arm or disarm through the GCS?