LibrePilot Forum

Development => Hardware => Topic started by: Obamjur on May 30, 2016, 06:16:48 pm

Title: CC3D "upgrade".
Post by: Obamjur on May 30, 2016, 06:16:48 pm

Hi, I have been flying my Diatone's Blade 200 & 250 with this CC3D board (http://www.surveilzone.com/OpenPilot-CC3D-32Bits-Flight-Controller--Protect-Case-for-Quadcopter-QAV250-450-%28Stright%29-g-1334 (http://www.surveilzone.com/OpenPilot-CC3D-32Bits-Flight-Controller--Protect-Case-for-Quadcopter-QAV250-450-%28Stright%29-g-1334)) with no problem, but I am missing those advanced features that only Revolution board has. I was wondering if this http://www.banggood.com/GY-87-10DOF-MPU6050-HMC5883L-BMP180-Sensor-Module-p-963792.html (http://www.banggood.com/GY-87-10DOF-MPU6050-HMC5883L-BMP180-Sensor-Module-p-963792.html) will work with my CC3D board. If yes, how to plug it in ? Thanks!

Title: Re: CC3D "upgrade".
Post by: f5soh on May 30, 2016, 06:55:16 pm

Nothing more can be supported, CC3D is almost full and run with a small amount of memory free.
The GPS is supported with only minimal features also, for memory reasons.

Title: Re: CC3D "upgrade".
Post by: Obamjur on May 31, 2016, 01:50:02 am

Understood, thanks!