LibrePilot Forum
Development => Firmware General => Topic started by: myflyer on May 19, 2016, 04:57:15 am
-
Bought a new quad worked fine wanted to run liber pilot to fine tune it. When I run the wizard it erase the board then when rebooting board it says. Timed out while booting. You will have to manually. Upgrade the board using the uploader plugin.
-
With the USB and battery unplugged...
In the Firmware tab select 'Upgrade & Erase.'
You'll be prompted to plug in the USB.
Wait for it because it takes a short while.
You'll be prompted to unplug the FC.
Wait half a minute, and plug it back in.
After that you can proceed with the Wizard.
-
Did not remembering seeing it to promp me to unplug the FC ( can you explain what is the FC ) I will try it after work and give you a up date. Thank you for helping and your quick response
-
FC is Filght Controller mounted on the quad. There's a cable(s) that plug into the Rx Receiver and four sets of wires that plug into the ESCs which control the motors.
I'm not 1000% sure that it prompts to remove USB but I'm 96% sure that it needs to be power cycled after upgrade.
If you still have problems the exact make/model of the quad would help, and/or pics of the various components.
-
Hi Sorry to butt in but I am having the same problem with my FC im not getting the disconnect prompt and don't know what to do?
-
Sometimes CC3D problems like this are caused by having an old bootloader and updating to BL4 (for CC3D) fixes the issue.