LibrePilot Forum
General Category => General Discussion => Topic started by: sv2fpv on April 28, 2016, 01:42:23 pm
-
I2C and compass no problem to me when booting
Revo & AuxMag & Oplink/PPM only
PROBLEMS WHEN BOOTING
1) ws2811/Led on servoOut6 sometimes do not light, after rebooting is ok
2) sometimes does not initialize the gps, after rebooting is ok
3) PPM, no "Input Alarm" on ws2811/Led, but sometimes I have no control, after rebooting is ok
I did not try to arm with these problems, only after rebooting.
what's wrong ?
sorry for my bad english
-
I think you can't arm is there is an alarm, in the health. BOOT red is an alarm, so I think will not let you arm. I can be wrong. If it so, please correct me.
-
Υes my English is not good
Thanks for your interest
1) In the first case after booting(connecting the battery) the ws2811/Led are off no light, "System Health" is all green, i did not try to arm, reconnect the battery and all good
2) Connecting the battery, "System Health" "GPS" alarm flashing black/red X & Red, wait up to 10 minutes but the ALARM remain, maybe not initialized, reconnect the battery 1-2 times and all good
3) PPM, connecting the battery, "System Health" no "Input Alarm", all green, but i have no control, turn OFF the radio "System Health" "Input Alarm" = Red, turn ON the radio "Input Alarm" = Green, i have no control, reconnect the battery and all good
not always happen, but sometimes different each time
-
Go to the firmware tab, press Halt, check the sequence in the bottom pane. you will see something like:
Sequence 1
Sequence 2
Sequence 3
Then press the Boot button on the top and check the sequence again.
Please post back.