LibrePilot Forum
Development => GCS General => Topic started by: zukenj on April 16, 2016, 03:21:17 pm
-
After build last nigth, I connect the usb to the boar and the board boot, but get no sugnal in the tx, also at the bottom right I can see that it says usb:Revolution but no signal. I try rescue, but it comes back that the board can't enter DFU (I think) mode.
Sent from my SM-N900P using Tapatalk
-
Board is always connected after you hit the button rescue
Board do a normal blinking ?
-
Thanks f5soh.
I was able to fix the issue. I did the Upgrade & Erase in version 15.09 and the run the Next branch and did the Upgrade & Erase, and now all is good.