LibrePilot Forum

General Category => General Discussion => Topic started by: dcruze on April 09, 2016, 05:17:07 pm

Title: Boot Fault Error After Crash
Post by: dcruze on April 09, 2016, 05:17:07 pm

I was flying my Eachine Racer 250 trying to tune it when I had a hard crash into the house. No it won't arm. If I look at the Flight Data screen I get a Boot Fault error.

How do I clear it or fix it?

Title: Re: Boot Fault Error After Crash
Post by: dcruze on April 09, 2016, 06:07:30 pm

I was able to get past the Boot Fault error by reloading my Firmware and re calibrating my controller

Title: Re: Boot Fault Error After Crash
Post by: dcruze on April 12, 2016, 11:50:47 pm

I thought I had this figured out, but today it will not arm.

Under Flight Data I have a Input Error which reads: System is in failsafe mode or Failed to update one or more of the accessory channels.

I have checked my controller and all of the channel are working, How can I check or reset Failsafe?

Anyone with ideas?

Title: Re: Boot Fault Error After Crash
Post by: dcruze on April 13, 2016, 12:11:28 am

I am using a Eachine Racer 250 with a FS-Th9x Transmiter and a Fr Ssky D8R XP Receiver

Title: Re: Boot Fault Error After Crash
Post by: f5soh on April 13, 2016, 10:31:00 am

In PWM, failsafe can be a channel/input you set manually and not active or hardware issue (wire cut...)

Redo Transmitter wizard