LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: Stuartambient on March 16, 2016, 11:30:54 pm
-
Hopefully you can see the picture clear enough to show things are not perfectly level, for some reason. Would being off by that much be a problem? It is sitting on a flat surface with some double side tape underneath. If I move the cc3d around a bit, just itself, I can be even on the horizon, so maybe I need to do a little shim on one side though it is not noticeably lopsided.
What do you think? Thanks!
Edit: I notice in the LP screen the horizon lines bounces up and down slightly. I may not understand this screen.
-
You can redo the level calibration on Attitude tab.
The only reference is the flight test, you can adjust level if needed using the Virtual attitude rotation.
-
-1 on Virtual roll seemed to get it centered. Not sure what you mean by "The only reference is the flight test". Gather you mean putting it up in the air ?