LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: adamchicago on March 07, 2016, 06:24:05 pm

Title: Which OSD for CC3D EVO - LibrePilot?
Post by: adamchicago on March 07, 2016, 06:24:05 pm
Hi, I would like to connect an OSD to a quadcopter with the CC3D EVO controller that is configured through LibrePilot.  Currently the "main" socket is used by the power/LED distribution board.

Any ideas??
Title: Re: Which OSD for CC3D EVO - LibrePilot?
Post by: f5soh on March 07, 2016, 06:32:48 pm
OSD is usually connected to one port (mainPort or flexiPort) running a telemetry at 57600bauds.

https://librepilot.atlassian.net/wiki/display/LPDOC/MinOPOSD+setup



Title: Re: Which OSD for CC3D EVO - LibrePilot?
Post by: adamchicago on March 07, 2016, 07:10:10 pm
Ok great...so a MinimOSD into the flexi port would work then?
Title: Re: Which OSD for CC3D EVO - LibrePilot?
Post by: f5soh on March 07, 2016, 07:16:11 pm
yes, and can also work on MainPort  :o
Title: Re: Which OSD for CC3D EVO - LibrePilot?
Post by: adamchicago on March 07, 2016, 08:46:28 pm
Great...thank you very much!!!!  Just ordered a MinimOSD:)
Title: Re: Which OSD for CC3D EVO - LibrePilot?
Post by: jtrout19 on March 08, 2016, 06:10:05 am
I got the micro minimosd. It works great aside from a couple issues flashing it with updated charset and firmware with my ftdi. If you start getting errors when flashing hitnthe reset button on the osd at the same time you hit the update fw button or update charset button. If you dont have a reset button on it you can pull the ground connection off the ftdi and hit the update buttons as you plug it back on.

Jumping the gun a bit here just thought i would share just in case you have issues.
Title: Re: Which OSD for CC3D EVO - LibrePilot?
Post by: adamchicago on March 08, 2016, 03:16:53 pm
Good to know...thank you.