LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: hegoak on January 11, 2016, 11:04:59 am
-
I have a problem, the alarm window out these messages:
RC INPUT:CRITICAL
One of the following conditions may be present:
-One or more of the r/c input channel types is not set.
On the CGS configuration page,make sure all inputs have a type set
- One or more of the r/c input channel types mappings are invalid
- The driver unintialized for one or more of the r/c input channel
- Current flight mode is undefined: this indicates a bug in the code
- Current flight mode set to guidance but flight status flight mode is reported a something
other than altitude hold
- During update of desired stabilization mode,flight status is reported reported a something
other than altitude stabilized 1,2,3,4,5 or 6
BOOT FAULT : CRITICAL
- System has failed to boot more than three times: system defaults have been set
SYSTEM CONFIGURATION: CRITICAL
One of the following conditions may be present:
- you have set up a GPS mode (poshold,RTB) to thr flight mode switch,and you may have
selected "basic (complementary)" fusion algorithm.
- Select "GPS Navigation (INS13)" in config / attitude tab / paremeters / attitude / estimation algorithim
-
Hi Hegoak, welcome :)
Double check the flight mode tab, you may remove all Gps modes.
CruizeControl is only allowed with attitude/rattitude, not rate
Rcinput looks normal is your receiver is not powered or inputs not configured.
I remove the duplicate post.
Laurent
-
BOOT FAULT : CRITICAL
- System has failed to boot more than three times: system defaults have been set
Cómo se corrige eso
-
Where I usually see this is if I make a bad setting that keeps it from booting.
Easy fix is to Erase Settings and start over.
OR - If you know that you changed something and it broke it, then once it boots like this, go and change that setting back to default, and next time it should boot normally.