LibrePilot Forum
Development => GCS General => Topic started by: jochene on December 19, 2015, 04:21:53 pm
-
Hello there,
have a problem with "Virtual Bar".
Once I steer aileron or elevator, the swash plate begins strongly to twitch.
When I switch on "Rate", everything is ok.
What can that be?
I use the "GCS 15.09 R159" with "CC3D mini"
A video I did, but it does not get uploaded.
Thank you
Jochen
-
I am guessing that it is in flight but not when on the ground (motor off).
I would first use Attitude mode and tune PIDs so that it flies in Attitude mode, then try Virtual Bar mode.
There are many tuning settings for Vbar in System -> Settings -> StabilizationSettings
I have never used Virtual Bar.
-
Hello there,
have a problem with "Virtual Bar".
Once I steer aileron or elevator, the swash plate begins strongly to twitch.
When I switch on "Rate", everything is ok.
What can that be?
I use the "GCS 15.09 R159" with "CC3D mini"
A video I did, but it does not get uploaded.
Thank you
Jochen
Hmm i cant confirm that, for me its just working. But im using the supermoon eclipse version of GCS and firmware. Just left the default settings on the stabilization screen
Udo
-
Hello there,
have a problem with "Virtual Bar".
Once I steer aileron or elevator, the swash plate begins strongly to twitch.
When I switch on "Rate", everything is ok.
What can that be?
I use the "GCS 15.09 R159" with "CC3D mini"
A video I did, but it does not get uploaded.
Thank you
Jochen
Hmm i cant confirm that, for me its just working. But im using the supermoon eclipse version of GCS and firmware. Just left the default settings on the stabilization screen
Udo
Hello Udo,
what is the supermoon eclipse version?
Can we write PM in german?
Jochen