LibrePilot Forum
General Category => General Discussion => Topic started by: achutam1 on March 15, 2018, 09:50:18 am
-
i am an absolute beginner and i'm really in trouble about the setting that needs to be done in librepilot.i have a cc3d and a frsky x4R SB receiver. i binded the receiver properly with my taranis qx7. and then i connected the X4R SB in the cc3d in the main port. then when i go to librepilot for vehicle setup wizard which setting should i choose ppm pwm or sbus. i tried sbus and rapid esc setting ( i have 12A emax simonk esc) then when i go to the next window in librepilot i connected my battery and esc beeps ensuring the connection after that when i disconnect the battery then esc doesnt beep and no confirmation is given. after that i tried to set up the end and startup point for motor but it doesnt work at all. it does nothing i tried tried and tried different ways but i couldnt so i came here for help. Thank you
-
To set end points you need to have your battery connected because it needs power, usb will not power the receiver. And you need to go through the wizards and click save.
Painless 360 on YouTube has good videos on setting up cc3d
-
https://librepilot.atlassian.net/wiki/spaces/LPDOC/pages/12058743/ESC+Calibration