LibrePilot Forum

General Category => General Discussion => Topic started by: cartf155 on August 21, 2017, 11:51:18 pm

Title: HELP! Controller CC3D and Ibus conection doesn't work.
Post by: cartf155 on August 21, 2017, 11:51:18 pm

Hi every one.
I am trying to set up my CC3D controller with LibrePilot.
I have conected ibus throught the main port, flexi port, and the principal port (PWM) and no one run...
I am using wizart setup , and in te point of ESC configuration, the BEEPS confirmation never sounds

Anyone has had the same problem?
I really need help.

Title: Re: HELP! Controller CC3D and Ibus conection doesn't work.
Post by: f5soh on August 22, 2017, 01:20:37 am

Hi, welcome.

The only way to connect IBus receiver to the CC3D is using the Flexiport.
(https://forum.librepilot.org/index.php?action=dlattach;topic=3759.0;attach=6569)
Configure the flexiport as Ibus and reboot the board, check the receiver activity found in Input tab and move sticks.

If you have init/no beeps issues with your Esc, simply revert the Output config banks as PWM-490Hz instead of PWMSync