LibrePilot Forum

General Category => General Discussion => Topic started by: DaveKersting on May 10, 2017, 02:26:50 am

Title: New CC3D board- programming help
Post by: DaveKersting on May 10, 2017, 02:26:50 am

So, had to put a new CC3D board in my quad (2nd one). The first one I loved. The quad was new and the board was set up perfectly. I consider myself intermediate. To save time, the 1st board, an expert help me set it up. This time, Im doing it. I dont want trainer, but i dont want expert either. I can send my lebra pilot settings if you tell me how. Im flyinga ZMR250.

Title: Re: New CC3D board- programming help
Post by: TheOtherCliff on May 10, 2017, 05:49:22 am

The "Vehicle Setup Wizard" built into the startup page of the GCS is what you need to use to set up a new quad.