LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: karla on January 25, 2017, 02:02:10 am
-
Hi,
AutoTune did a great job tuning 2 of my quads as described before
https://forum.librepilot.org/index.php?topic=2949.msg20579#msg20579 (https://forum.librepilot.org/index.php?topic=2949.msg20579#msg20579)
But last time I ran AutoTune on the smaller 180 size quad it shaked rather much and after some 5-10 seconds it rolled over and crashed before I could switch back to bank #1 PID settings. This time I was using the heavier configuration with a camera on it. While the first successful AutoTune was made in the light configuration. The PIDs on bank #1 was used to fly it. Could that be the cause of crash?
What is the work around?
I would like to get it tuned for the heavier configuration.
This actually happened 2 times so I have no hopes it will just work next time I try.
Thanks a lot.
-
One requirement for AutoTune is that the PIDs you are using during AutoTune do not oscillate (or even "ring" badly).
If you tune a quad, then add a camera, it is heavier and will oscillate.
You can do it the other way around just fine: If you successfully tune it with a camera, then remove the camera, it does not oscillate, and you can use those PIDs to run AT again.
I know that recently I discussed using PID banks so you could have one tune for camera and one tune for no camera. I should have made it more clear then...
-
Yes, it basically mean I will have to tune it manually first. Then run AutoTune.
Okay.
-
If you have an oscillation or ringing in normal Attitude mode flight, you can cut R/P/Y PIDs all in half should make it OK to fly AutoTune.
-
Thanks! thats exactly the advise I needed.