LibrePilot Forum

General Category => General Discussion => Topic started by: Mmarciniak on January 21, 2017, 08:25:09 pm

Title: Librepilot won't work with reciever
Post by: Mmarciniak on January 21, 2017, 08:25:09 pm

When I am in librepilot, I can go throught most of the initial setup just fine until I get to "move all controls to maximum extents".

I move the sticks around on my reciever and nothing happens. Anybody have a solution for this?

I have an openpilot cc3d, with an fs ia6 reciever. The controller is a fs 16.

Max

Title: Re: Librepilot won't work with reciever
Post by: f5soh on January 21, 2017, 08:35:08 pm

Hi,
Some users expect the same behavior but we cannot reproduce.

Can you post the full config file you have while you are locked without stick moving in wizard ?
Go to File Menu > Help > Export UAV data...

Title: Re: Librepilot won't work with reciever
Post by: Mmarciniak on January 21, 2017, 08:59:46 pm

Yes i have attached it, thank you for the quick response

Title: Re: Librepilot won't work with reciever
Post by: f5soh on January 21, 2017, 09:02:18 pm

Go to File Menu > Help > Export UAV data...

While the board is connected and running, just when the Tx wizard show the stick not moving.

Title: Re: Librepilot won't work with reciever
Post by: Mmarciniak on January 21, 2017, 09:08:19 pm

That is what I sent

Title: Re: Librepilot won't work with reciever
Post by: f5soh on January 21, 2017, 09:10:29 pm

Sorry, you sent a normal config file.

Full config file generated using the Help > Export UAV data... will give a 60Kb file

Title: Re: Librepilot won't work with reciever
Post by: Mmarciniak on January 21, 2017, 09:13:51 pm

oh now i see, here it is

Title: Re: Librepilot won't work with reciever
Post by: f5soh on January 21, 2017, 09:32:40 pm

Please try setting a flightmode in your radio and do not skip the FlightMode switch detection

Title: Re: Librepilot won't work with reciever
Post by: Mmarciniak on January 21, 2017, 10:02:41 pm

Yes that worked, I appreciate all your help