LibrePilot Forum
General Category => General Discussion => Topic started by: Bri_man561 on January 05, 2017, 06:24:34 pm
-
Hello all, just got a QAV 250 and im running into some issues. I went to configure it last ngiht to get it up and running and everything works great up until i get to the Arming/Disarming. I know there's probably a thread about this but i couldn't find it anywhere. I set it to YAW right and the quad does not want to start up. Im dying to get this thing going and hoping someone can help me. Im using a Futaba T8J, been stuck on this for hours last night and just want to fly =(. It did work at one point but i had to move both toggles and it was not on what i set it to. i was wondering if this was fixed in the new V16? i believe i was using V15 and i legit tried over 15 times to try and figure this out.
-
If quad do not arm there i something wrong with your configuration.
Information is displayed as alarms in Flight Data tab / SysteamHealth panel.
Click on SystemHealth / alarm and you get some help about common issues.
-
configuration as in the motor part in Libre? Im new to all this and im kind of stumped...
-
I do not know what do you mean about motors, there is Configuration tab and Flight Data tab.
(https://forum.librepilot.org/index.php?action=dlattach;topic=2855.0;attach=4936)
And Wiki:
https://librepilot.atlassian.net/wiki/display/LPDOC/User+Manual
Every (https://forum.librepilot.org/index.php?action=dlattach;topic=2855.0;attach=4938) icon in GCS point to the wiki page for help
-
ok i see that, what do you think i need to configure?
-
I don't know what you need to configure, i don't have a crystal ball at home.
Just check the SystemHealth for alarms that prevent for arming.
-
ok never knew it could do that