LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: vgwit on December 18, 2016, 10:40:35 am

Title: Failsafe on CC3D - can not get it to work as described
Post by: vgwit on December 18, 2016, 10:40:35 am

I use FlySky i6 TX. With its failsafe settings set to ON and after TX turn off input signals in LP configuration  do not depent on slider's positions set in LB failsafe tab for any channel. It looks like CC3D does not trigger failsafe.
Have tried to set TX throttle failsafe to OFF. No change.
When CC3D decides to trigger failsafe?

Thanks.

Title: Re: Failsafe on CC3D - can not get it to work as described
Post by: f5soh on December 18, 2016, 11:12:47 am

After you turn your Tx off, if the receiver still sending the last rc stick position the board cannot known there is a failsafe.
In this case you should setup the failsafe in your receiver.

The onboard failsafe works in case the receiver stop sending pulses or a wire is disconnected.

You can look at SystemHealth, if INPUT alarm goes Orange there is a board failsafe.

Title: Re: Failsafe on CC3D - can not get it to work as described
Post by: quadster51 on January 08, 2017, 02:18:32 am

i just set up LP and failsafe on a fs-i6  and cc3d.
i didn't set it up on the tx and just did it in LP -100% ch1,5&6 or 
throttle, accessory 0&1.
worked like a charm.