LibrePilot Forum
General Category => General Discussion => Topic started by: manikmodder01 on October 03, 2016, 05:16:12 am
-
First off who first racing quad I bought came with a standard cc3d unit it was great the setup was so easy the vehicle Setup Wizard in the transmitter Setup Wizard made it a breeze those two things alone save me hours and hours days actually time. Well unfortunately I've had purchased a naze32 rev.5 bad luck on that board then another. Revo not sure what killed it but flew great about a week. Then a spracing f3 acro board it runs cleanflight. Betaflight. And raceflight. Question is can i run libre on it stupid cleanflight works when connected to computer but unplug it nothing pulling my hair out on this 1
Sent from my LGMS330 using Tapatalk
-
No, LP currently has no support for F3 processors. It has been discussed as a possible future addition but no firm plans have been made. If support is added it will be several months at the earliest.
-
Well thanks for replying so quickly my first flight controller with an open pilot cc3d unit and I just it was just so easy to set up and I don't know why I bought a naze32 then a f3 after that keep up the good work and hopefully someday I'll be able to afford another cc3d unit I know they're only like $15 now but currently been laid off from work and everything is going bad
Sent from my LGMS330 using Tapatalk