LibrePilot Forum
General Category => General Discussion => Topic started by: hawkview on September 11, 2016, 09:38:13 am
-
Hello librepilot folks
I have solder my esc straight to revo and would like to change the settings on the esc e.g turn on active damping.
Do I need to unsolder esc or can i just use my arduino jumper wires to program the esc in place or will I damage revo if I do this?
Thanks
-
Just in case anyone comes across this on a search.
The answer as of gcs 16 is no
It will not work you need to unsolder the signal wire to the esc, ground can stay connected
All flashed now with one shot working on a revo.
-
This is something that is being worked on by a developer. I don't expect it in the coming 16.09 release? But I there is talk to have another release much sooner than a year from 16.09. :)