LibrePilot Forum
General Category => General Discussion => Topic started by: cchavezpadky on August 30, 2016, 06:59:00 pm
-
Hello, I am new to quads. This is my first build.
I have a CC3D Flight controller and a FrySky-D8R-II-Plus
Does anyone have a wiring scheme I could follow. I am not sure where to cable up my FC to the Receiver.
I appreciate any and all help and thank you in advance.
-
Hi, welcome.
You should do the wiring like that:
(https://librepilot.atlassian.net/wiki/download/attachments/2818090/CC3D_PWM.png)
Every connector position doesn't matter, the Tx Wizard will detect the activity while you move a specific stick/switch.
(https://forum.librepilot.org/index.php?action=dlattach;topic=2240.0;attach=4048)
-
f5soh Thank you for the reply.
I'm looking at my wire harness and the color code seems different, based on the picture.
Would you mind taking a second and helping me with pin position.
My harness -6 cables
This is the cable that came with the CC3D.
1- Black, Red, White "3" wires
2- Red "1" Wire
3- Purple "1" Wire
4- Green "1" Wire
5- Yellow "1" Wire
6- Black "1" Wire
if I am hearing you correctly.
On the Receiver -
port 1 goes to cable harness (Black, Red, White)
2-6 can be in any order?
Thank you again
-
The order doesn't really matter but for convenience troubleshooting later they're usually connected in the same order they come off the other connector.
-
Thanks, going to give it a try tonight or tomorrow. Appreciate the help everyone.
-
I just can get my flight mode switch working if keep channel five empty and connect last 2 wires in channel 6 and 7. I got same board and same receiver