LibrePilot Forum

General Category => General Discussion => Topic started by: Ghost0 on August 15, 2016, 08:22:52 pm

Title: everything fine after flashing librepilot arms but no power to motors pls help
Post by: Ghost0 on August 15, 2016, 08:22:52 pm

 >:( :( can anybody pls help me as ive jus bought a new Eachine falcon 250 and flashed libre and adjusted pids then disconected and all great...
Then went to use it and it binded so i then armed it and got my constant leds and a beep as usual but now it dosent do any thing at all,im new to this so in laymens terms pls thanks in advance to whoever cheers cris

Title: Re: everything fine after flashing librepilot arms but no power to motors pls help
Post by: nacholibre on August 16, 2016, 07:11:36 am

upload or screenshot your flightdata. sounds like escs might not be calibrated. Did you run the full set up wizard? Did you build it yourself or was it pre-assembled? Upload those items and someone will be able to help. Some of the biggest help comes from European countries, so sure alot of the admins and such arent on right now give it sometime friend. But go to flight data and it should give you a hint to what the issue is. It will be highlight in red. Thats what you want a screen shot of. and UAV log.

Title: Re: everything fine after flashing librepilot arms but no power to motors pls help
Post by: TheOtherCliff on August 21, 2016, 10:24:51 pm

Yes.  After you flash LibrePilot, you must do a complete Wizard setup.