LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: desi_joe on August 12, 2016, 07:02:30 pm

Title: CC3D Horizontal level is off, even after calibration
Post by: desi_joe on August 12, 2016, 07:02:30 pm

Hi,

I just upgraded my QAV250 from a regular cc3d to Revo but I am running into some issues.

1. CC3D Horizontal level is off, even after calibration.  I was able to level it only once after updating the firmware but, it's off level again after reconnecting the battery.

2. I have a Ubox 8 GPS and I followed all the GPS config steps yet the board doesn't see the GPS onec I reconnect the battery. 

Thanks for any help!

-DJ

Title: Re: CC3D Horizontal level is off, even after calibration
Post by: f5soh on August 12, 2016, 11:44:24 pm

Hi, welcome.

How is mounted/oriented the board ?

Title: Re: CC3D Horizontal level is off, even after calibration
Post by: Mikerand on August 21, 2016, 02:06:31 am

Double check the board itself is level inside the case. I had to cut and trim case and make my Atom level inside its case.

Title: Re: CC3D Horizontal level is off, even after calibration
Post by: startrek66 on August 21, 2016, 10:37:24 am

For gps read this
https://forum.librepilot.org/index.php?topic=868.0

For level off are you sure that perform a correct procedure for save data?

Inviato dal mio SM-G800F utilizzando Tapatalk