LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: Badboar65 on July 31, 2016, 12:11:40 am

Title: Can't Save Input When Adding Accessory Channels
Post by: Badboar65 on July 31, 2016, 12:11:40 am

I am trying to setup 2 accessory channels on my Turnigy 9x to use Easy Tune.  After completing the process, input will not save.  Originally I set accessory 0 and 1 on channels 7 and 8 of the Turnigy 9x.  The manual says those are the aux channels.  Unfortunately the pots I am trying to use only work on channels 5 and 6 of the radio.  But regardless of the operation I still can't save the changes and move forward.  I believe the issue is set up but at this point I am unsure.  I did receive a message saying the throttle is out of range and I should redo the TX calibration.  I have performed this at least 8 times without achieving any success.

Any suggestions would be appreciated!

Thanks

Title: Re: Can't Save Input When Adding Accessory Channels
Post by: Badboar65 on August 01, 2016, 03:41:51 am

SOLVED !!!!!!!!