LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: ccameselle on July 11, 2016, 03:31:45 pm

Title: AUX1 and AUX2 not being recognized
Post by: ccameselle on July 11, 2016, 03:31:45 pm

Hello everyone,

I have a problem with my CC3D. It is not recognizing the AUX 1 or AUX 2. I have done the transmitter wizard 3 times and nothing. I have the same set up in 4 more quads and they work fine. The funny thing on this one is that the Yaw is picked up by channel 5 and not channel 4. I have re wire the receiver and the CC3D also 3 times. To make sure that the wire are in the correct order and still nothing. Any help with this will be greatly appreciated

Title: Re: AUX1 and AUX2 not being recognized
Post by: Daxo on July 11, 2016, 07:01:42 pm

Radio?

Title: Re: AUX1 and AUX2 not being recognized
Post by: ccameselle on July 12, 2016, 05:44:10 pm

 :o :o :o :-[ :-[ :-[ :-\ :-\ :-\ :-\
Turnigy i10 with a FlySky FS-iA6 Receiver 6CH

Title: Re: AUX1 and AUX2 not being recognized
Post by: Daxo on July 13, 2016, 05:16:16 pm

Don't have any experience with that radio but, when you connect the battery, is your  receiver on? Led lights up on cc3d and receiver?

Title: Re: AUX1 and AUX2 not being recognized
Post by: f5soh on July 13, 2016, 05:28:21 pm

Try monitoring the receiver activity moving one stick/switch at once.

Go to UAVOBrowser and search for ReceiverActivity in Data side.
(https://forum.librepilot.org/index.php?action=dlattach;topic=1978.0;attach=3640)

The only variable between setups is the CC3D board ? Same radio profile and receiver ?

Title: Re: AUX1 and AUX2 not being recognized
Post by: TheOtherCliff on August 04, 2016, 08:29:42 am

For future reference, this is typically caused by the transmitter needing some configuration to even output the switch onto a channel.  :)

Much less frequently from PWM RC inputs without a wire connected for that channel, or from other protocols with a higher channel than is supported.