LibrePilot Forum

Development => GCS General => Topic started by: TMGsi on June 06, 2016, 05:39:29 pm

Title: I can not connect to Revolution in GCS Librepilot
Post by: TMGsi on June 06, 2016, 05:39:29 pm

Hello.

I can not connect to Revolution in LibrePilot.
I can connect to cc3d but cc3drevolution not.
What can it be?

Thank you.

Title: Re: I can not connect to Revolution in GCS Librepilot
Post by: f5soh on June 06, 2016, 06:35:55 pm

Seems legit, the "Revolution" is not a know board.  :)
There is CC3D boards and Revolution boards.

What about blinking ?
Do not connect both boards at same time.

Title: Re: I can not connect to Revolution in GCS Librepilot
Post by: TMGsi on June 06, 2016, 11:45:49 pm

I own the two boards,


connect the cc3d in librepilot normally.
 But the revolution can not. The windows emits sound when I plug the revolution, but there is no link with the librepilot. in revolution flashing orange light twice fast and slow blue

the Windows device manager. see "coptercontrol virtual com port (com10) to cc3d
and  "revolution virtual com port (com11) to revolution.

Title: Re: I can not connect to Revolution in GCS Librepilot
Post by: f5soh on June 06, 2016, 11:49:39 pm

How about the small bars Tx/Rx close to the connection button ?

Title: Re: I can not connect to Revolution in GCS Librepilot
Post by: TMGsi on June 06, 2016, 11:58:44 pm

only one green in Tx

Title: Re: I can not connect to Revolution in GCS Librepilot
Post by: f5soh on June 07, 2016, 12:24:32 am

Reinstall the driver, be sure you uninstall/install the right "USB composite device"

Take a look here:
https://librepilot.atlassian.net/wiki/display/LPDOC/Troubleshooting

Title: Re: I can not connect to Revolution in GCS Librepilot
Post by: TMGsi on June 07, 2016, 12:37:39 am

Thank you very much. it's working. solved.