LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: Migarve on June 04, 2016, 03:19:28 pm

Title: Arming problem in Eachine 250 Racer
Post by: Migarve on June 04, 2016, 03:19:28 pm

Hello everyone:

So I have recently bought a new quad, and a new transmitter for it (FlySky I6 6CH 2.4GHz)
I have done all the steps with the configure wizard, but I cannot arm it. I have tried doing the default, yaw right while throttle off, but nothing happens. I also tried to configure one switch in the controler to be the accessory 0, and change the arming settings. I even tried to configure it as always armed, but nothing worked.

Does the CC3D have any light to indicate that it is armed?
I always click save when I am done, but does that save the settings in the quad, or only in a file in the computer that i have to upload? Please help.

Thank you.

Title: Re: Arming problem in Eachine 250 Racer
Post by: cjen0513 on June 06, 2016, 11:29:27 pm

I have same issue. I can not arm my 250 racer.
I have followed the wizard "erase and upgrade", all the way to the end. It arms once a while and just for few seconds.
Please HELP!

Title: Re: Arming problem in Eachine 250 Racer
Post by: f5soh on June 06, 2016, 11:43:56 pm

Please check the SystemHealth panel for alarms.
Usually something that prevent for arming.
 
Post your config file: File Export UAV setting