LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: THATDONFC on May 07, 2016, 09:30:51 pm

Title: Help setting arming switch
Post by: THATDONFC on May 07, 2016, 09:30:51 pm

I need some help setting the arming/disarming switch. I can't seem to figure out which channel I need to program.

I have a SRD250 V3 with Radiolink AT9 tx. I would like to set my arming switch to switch B but I don't know which channel that corresponds to.

I've attached a copy of my .uav file.

Thanks for your help!

Title: Re: Help setting arming switch
Post by: f5soh on May 07, 2016, 09:46:04 pm

Hi, welcome.

Assign first your "B" switch to one receiver output, maybe the channel6 that left.

Connect last input6 wire (assuming you are using PWM input with all wires) Sorry, Sbus
Redo the transmitter wizard and move quickly the switch when the wizard ask for Accesory0.

Now you can use the Accessory0 as Arming switch, be sure you set the Accessory0 neutral to middle.

Title: Re: Help setting arming switch
Post by: THATDONFC on May 08, 2016, 01:34:01 am

Quote from: f5soh on May 07, 2016, 09:46:04 pm

Hi, welcome.

Assign first your "B" switch to one receiver output, maybe the channel6 that left.

Connect last input6 wire (assuming you are using PWM input with all wires) Sorry, Sbus
Redo the transmitter wizard and move quickly the switch when the wizard ask for Accesory0.

Now you can use the Accessory0 as Arming switch, be sure you set the Accessory0 neutral to middle.

Ok I got it to work. Now when I flip the switch down, the motors arm. How can I change it so the motors arm when I flip the switch up?

Title: Re: Help setting arming switch
Post by: THATDONFC on May 10, 2016, 07:58:32 am

Any help here?

Title: Re: Help setting arming switch
Post by: NicholasDavid on May 10, 2016, 02:05:01 pm

Reverse the accessory channel in your radio or in the GCS. Simple....