LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: irishluck on May 06, 2016, 02:07:53 am
-
So im having issues getting my quadcopter to take off straight up with out it going sideways first.
I had the quad programmed on a level surface. Used a level to make sure of that.
But Im not sure what else to do to actually get it to take off straight?
Also I still am not understanding how to use PID setting?
Can someone help guide me on what do to here?
My quad is a 500mm in diameter. Using I think 900kv motors with 30amp esc's. Running with a 3S 5200mAh battery.
CC3D flight controller. Frsky radio with sbus.
I am running the Eachine FPV camera on it as well.
Any help would be great.
-
There are some other posts on this. I had the same problem for many months. I made sure my quad was not twisted, or unbalanced, I fixed it by simply increasing the accelerometer filters on the TAB Attitude>settings. You can do it starting with 5, than 7, than 8, too much is also not good. dont ask me why but after this ( my filter is at 12) my quad starts the flight straight and stays straight.
I saw another problem which was related to the output tab. Make sure your escs are calibrated, and the minimum spinning is set to a flawless rotation of the motors, and the banks are all set to the same speedrate, rapid esc, oneshot...
-
Should the minimal spinning of the motors all be the same number?
-
They should all be "about" the same number. They may be the same but not likely. Most of the time, They won't be. A few numbers off either direction is fine. You know you have a problem if it's like 10-15 off