LibrePilot Forum

Users => Vehicles - MultiRotors => Topic started by: Christiangrau on April 28, 2016, 03:47:35 pm

Title: Replacing OPlink with Dragon Link V3
Post by: Christiangrau on April 28, 2016, 03:47:35 pm

Hello Guys!

I'm about to get my Dragon Link v3 which can both do ppm and telemetry at the same time. So the idea is to replace my OPlink (genuine 8) ) because i wasn't satisfied with the range i got out of it, but i don't wanna lose the telemetry to my computer. So my question is, is it possible to have controll + telemtry with dragon link? :)

Thanks

Title: Re: Replacing OPlink with Dragon Link V3
Post by: TheOtherCliff on April 28, 2016, 05:19:29 pm

It might be if DragonLink has a serial input on the receiver and a serial or USB telemetry output on the transmitter.
If not, I would suggest looking at TauLabs or dRonin.  Hope this helps.

Title: Re: Replacing OPlink with Dragon Link V3
Post by: Christiangrau on April 28, 2016, 11:06:08 pm

Yeah the Dragon link do support Serial in/out on the Rx pins, and the Tx have bluetooth so i should be able to connect to GSC. It would be awesome if this will be working together with librepilot firmware and my revo+v9 gps

Title: Re: Replacing OPlink with Dragon Link V3
Post by: Christiangrau on April 28, 2016, 11:29:50 pm

It seems like i could use the Receiver Port to connect to serial in/out on dragon link Rx, but since i use OSD, GPS, Current meter.. All ports are pretty much busy :P

Title: Re: Replacing OPlink with Dragon Link V3
Post by: buzzdev on May 10, 2016, 03:00:39 pm

Hi all,
i also bought dragonlink v3 and trying to achieve the same.

Did you have any luck with the setup?

thanx