LibrePilot Forum
General Category => General Discussion => Topic started by: rubberducky on April 05, 2016, 04:09:43 pm
-
hello,
i set up my new quadcopter with the cc3d revo board.
It flys very well. All ok.
No channel of my RC TX is reverse, only throttle.
If i move TX Sticks right it flys right, forward it nicks down, yaw also ok.
I installed the board with the darts forward in flightdirection, usb at the left side.
But i wondered ...
All displays in my GCS dashboard are 180 degrees reverse.
Also the horizon in my OSD is reverse.
I tried to change the virtual board settings in attitude and set yaw to 180.
Then i have a correct vehicle view, but the copter will not fly, because all sticks move reverse.
Mmhhh...i found nothing about this problem in the user manual.
Can anyone help me?
greetings
Jürgen, Germany
-
The PFD react like when you are "inside" vehicle.
If you roll to the left you see more "ground" to the left...
-
No,
If i move the stick of my TX to left, the view rolls to the right side in my PFD.
Thats the problem.
Also, the horizon in my OSD is reverse
jürgen
-
It fly or not ?
Post a picture how you mounted the board and post your config file.
-
It flys very well and to the correct direction.
Problem is only the reverse view.
But the reverse OSD is a problem, so i cant fly FPV.
Jürgen
-
Here is the normal PFD behavior using a Revolution board with default settings: All virtual rotation numbers set to 0.
https://www.youtube.com/watch?v=5hqS_PQT2Q8
-
Ok., thank you ... So it is normal.
Board left, PFD right ...
Ahh, now i understand ...
When i sit in the cockpit the view to the ground is like the view in the PFD
:-* :-* :-*
jürgen
-
Exactly :)