LibrePilot Forum

General Category => General Discussion => Topic started by: jclassic1 on April 02, 2016, 07:40:19 am

Title: cleanflight on cc3d atom
Post by: jclassic1 on April 02, 2016, 07:40:19 am

I would like to install cleanflight onto my CC3D Atom and have bought a USB to TTL UART CH340 Serial Converter Module but have no idea how to use it.
I need cleanflight to see a virtual serial port but keep getting failed to open port so I am obviously doing something wrong.
Need some help on this if anyone has done this before.

Thanks

John

Title: Re: cleanflight on cc3d atom
Post by: Mateusz on April 02, 2016, 08:05:25 am

Maybe higher chances to get answer about cleanflight firmware are by asking it on cleanflight forum... I would like to help, but I don't now much about that firmware.

Title: Re: cleanflight on cc3d atom
Post by: jclassic1 on April 02, 2016, 04:29:05 pm

Thanks for your reply,
for now I will continue to use my KK 2.1.5 board which is very easy to change the firmware until I can figure out how to load cleanflight onto my CC3D.

John

Title: Re: cleanflight on cc3d atom
Post by: Mateusz on April 02, 2016, 07:15:21 pm

It is also easy to update to LibrePilot firmware, just connect over USB and click erase-upgrade done.