LibrePilot Forum
Users => Vehicles - MultiRotors => Topic started by: conan62 on July 07, 2016, 10:30:58 am
-
All,
Just installed LibrePilot on my windows 7 and connected my CC3D. First I couldn't upgrade the firmware as it kept showing "you will have to manually upgrade the board" when it tried to go to bootloader mode. I figured my BL version is 3 and I will need version 4. Followed the instruction from Bootloader Upgrade section on Wiki, it didn't have "Open" bottom on the screen for me to upload bu_cc3d.opfw no matter how many times I tried.
I also followed the discussion in this forum to reinstall LP program and make sure USB connection have no problem. Still the same problem. I am stuck and appreciate much any idea.
-
Hi, welcome.
I think you miss the important stuff like "with the board disconnected from USB" in wiki page:
https://librepilot.atlassian.net/wiki/display/LPDOC/Firmware+Tab
- First Disconnect board
- Next Rescue or Upgrade&Erase button
- Finally Connect board before the time out.
Try this and load the bu_cc3d.opfw file.
https://librepilot.atlassian.net/wiki/display/LPDOC/Firmware+Rescue
-
Hi,
I did disconnect the board from USB before hitting Rescue or Upgrade&Erase button. It then asked me to connect the board in 20 seconds. I did and LibrePilot found the board and then nothing happened. There is no "Open" button like in the video. :'(
This is a brand new CC3D board. Is it possible this is DOA?
-
Try disconnect all wiring from the board, use only USB.
- Disconnect board
- Rescue button
- Connect board
If nothing works, ask for a replacement.
-
Problem solved. I used another PC and firmware upgraded without any issue this time. Still don't know why it didn't work on the first PC....