LibrePilot Forum
Development => GCS General => Topic started by: meganeura on January 04, 2016, 07:53:44 pm
-
Hello everyone,
I received a small DYS x160 from a friend who asked me to help him to do the setup.
It comes with a CC3D (the only non-welded component !!) with a Cleanflight firmeware.
I don't know anything about CF, so I flashed + upgrade the CC3D with LP
Everything works except that .....
numbering engine:
CF: 4,2,1,3
LP: 1,2,3,4
As everything is welded it is impossible to make a change with wires or connectors.
Do you think it would be possible under LP to change the location of the engines?
For example in the output menu:
# - Bank Assignement
1 1 VTOLMotor NW
2 1 VTOLMotor NE
3 1 VTOLMotor SE
4 1 VTOLMotor SW
modified by
# - Bank Assignement
4 1 VTOLMotor NW
2 1 VTOLMotor NE
1 1 VTOLMotor SE
3 1 VTOLMotor SW
Thanks !
-
Maybe like that ?
(https://forum.librepilot.org/index.php?action=dlattach;topic=546.0;attach=1020)
(https://forum.librepilot.org/index.php?action=dlattach;topic=546.0;attach=1022)
-
Hello f5soh,
Thanks for your reply.
With a 'normal' mutirotor it's easy to change some wires or connectors,but
the DYS x160 was designed wireless and to used with CF.
In fact I would like to make this (photo).
Do you think it's possible ?
-
Yes, just edit the outputs you want like i posted.
Config > Vehicle
(https://forum.librepilot.org/index.php?action=dlattach;topic=546.0;attach=1020)
-
Hello,
Aaaarg .....tough night: it was back to school in Belgium.
I would do a test tonight.
-
FYI, I received an AR7700.
The PPM works perfectly and I will try this week on a DIY quadcopter the SRXL !!
Thank you for this great work and have a nice day. :)
-
Hi f5soh
After a complete reset, the installation of a new receiver, re configuration, the X160 has flying. ;D
The channel change works but not the 'bitmap' from the diagram, so I thought it would not work: big mistake.
This is not my favorit quad, but with the one it's very nice to fly around the house.
once again thank you !!!!
-
Great :)